Clearing Ipv6 Traffic Statistics; Deleting Ipv6 Session Flows; Displaying Global Ipv6 Information; Displaying Ipv6 Cache Information - Dell PowerConnect B-RX Configuration Manual

43

Displaying global IPv6 information

BigIron RX# clear ipv6 route 2000:7838::/32
Syntax: clear ipv6 route [<ipv6-prefix>/<prefix-length>]
The <ipv6-prefix>/<prefix-length> parameter clears routes associated with a particular IPv6 prefix.
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the <prefix-length> parameter as a decimal value. A
slash mark (/) must follow the <ipv6-prefix> parameter and precede the <prefix-length>
parameter.

Clearing IPv6 traffic statistics

To clear all IPv6 traffic statistics (reset all fields to zero), enter the following command at the
Privileged EXEC level or any of the Config levels of the CLI.
BigIron RX(config)# clear ipv6 traffic
Syntax: clear ipv6 traffic

Deleting IPv6 session flows

To delete all flows from the IPv6 session cache, enter the following command.
BigIron RX# clear ipv6 flows
Syntax: clear ipv6 flows
Displaying global IPv6 information
You can display output for the following global IPv6 parameters:
•
•
•
•
•
•
•
•

Displaying IPv6 cache information

The IPv6 cache contains an IPv6 host table that has indices to the next hop gateway and the router
interface on which the route was learned.
To display IPv6 cache information, enter the following command at any CLI level:
1106
IPv6 cache.
IPv6 interfaces.
IPv6 neighbors.
IPv6 route table.
Local IPv6 routers.
IPv6 TCP connections and the status of individual connections.
IPv6 traffic statistics.
IPv6 session flows
BigIron RX Series Configuration Guide
53-1002253-01