Dell PowerConnect B-RX Configuration Manual page 344

9
Configuring LLDP
Port description
The port description TLV identifies the port from which the LLDP agent transmitted the
advertisement. The port description is taken from the ifDescr MIB object from MIB-II.
By default, the port description is automatically advertised when LLDP is enabled on a global basis.
To disable advertisement of the port description, enter a command such as the following.
BigIron RX(config)#no lldp advertise port-description ports e 2/4 to 2/12
The port description will appear similar to the following on the remote device, and in the CLI display
output on the Brocade device (show lldp local-info).
Syntax: [no] lldp advertise port-description ports ethernet <slotnum/portnum> | all
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
System capabilities
The system capabilities TLV identifies the primary functions of the device and indicates whether
these primary functions are enabled. The primary functions can be one or more of the following
(more than one for example, if the device is both a bridge and a router):
•
•
•
•
•
•
•
•
System capabilities for Brocade devices are based on the type of software image in use.
By default, the system capabilities are automatically advertised when LLDP is enabled on a global
basis. To disable this advertisement, enter a command such as the following.
BigIron RX(config)#no lldp advertise system-capabilities ports e 2/4 to 2/12
The system capabilities will appear similar to the following on the remote device, and in the CLI
display output on the Brocade device (show lldp local-info).
Syntax: [no] lldp advertise system-capabilities ports ethernet <slotnum/portnum> | all
268
Port description: "GigabitEthernet20"
Repeater
Bridge
WLAN access point
Router
Telephone
DOCSIS cable device
Station only (devices that implement end station capability)
Other
System capabilities :
Enabled capabilities:
bridge
bridge
BigIron RX Series Configuration Guide
53-1002253-01