Dell PowerConnect B-RX Configuration Manual page 265

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

Setting the rate limit to ARP packets on an interface
You can limit the number of ARP packets the device will accept each second by entering the
arp-port-rate-limit command. However, if you want to apply a limit on the rate that ARP packets flow
on an interface of a Layer 3 Switch, enter a command such as the following.
BigIron RX(config)#interface ethernet 1/4
BigIron RX(config-vif-10)#arp-port-rate-limit 2000
Syntax: [no] arp-port-rate-limit <rate>
There is no default value for <rate>. Enter 0–30,000.
Displaying the rate limit for ARP packets
To determine how many ARP packets were dropped by an interface due to the configured rate limit
for ARP packets, enter a command such as the following.
LP-1#show ip traffic arp
ARP Statistics
1400 total recv, 1400 req recv, 0 req sent
0 pending drop, 0 invalid source, 0 invalid dest
ARP Rate Limiting Statistics
Interface
ethernet1/1
ethernet1/2
ethernet1/3
ethernet1/4
The example above displays the LP processed 50 packets every second and dropped any addtional
packets.
Syntax: show ip traffic arp
This column...
Interface
Received
Processed
Dropped (Rate-limited)
BigIron RX Series Configuration Guide
53-1002253-01
The interface level configuration overrides the global configuration for a specific port.
The command is supported on Layer 3 Switches only.
There is no default value for <rate>. Enter 0–30,000.
If the value of <rate> is entered as 0, the interface will stop processing ARP packets
immediately.
You can go to interface trunk mode to configure the ARP port rate limit. When configured over
trunk interface (i.e. on the lead port) the same limit will be configured on each and every port
in the trunk.
ARP rate limiting is only supported on physical interfaces (virtual interfaces (ve) are not
supported).
Received
184200
0
0
184200
Configuring ARP parameters
Processed
Dropped(Rate-limted)
700
0
0
700
Displays...
The interface on the device.
Number of ARP packets received by the interface.
Number of ARP packets processed by the interface.
Number of ARP packets dropped by the interface.
183500
0
0
183500
7
189

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents