Dell PowerConnect B-RX Configuration Manual page 472

13
Displaying RSTP information
TABLE 81
This field...
forceVersion
MigrateTime
txHoldCount
Port
Role
State
Path Cost
Priority
AdminOperEdge
AdminP2PMac
DesignatedPriority
396
The show rstp detail command output (Continued)
Displays...
the configured version of the bridge:
•
0 – The bridge has been forced to operate in an STP compatible mode.
•
2 – The bridge has been forced to operate in an RSTP mode.
The number of seconds the bridge took to migrate from STP to RSTP mode.
The number of BPDUs that can be transmitted per Hello Interval. The default
is 3.
ID of the port in slot#/port# format.
The current role of the port:
•
Root
•
Designated
•
Alternate
•
Backup
•
Disabled
Refer to
roles.
The port's current RSTP state. A port can have one of the following states:
•
Forwarding
•
Discarding
•
Learning
•
Disabled
Refer to
states"
The configured path cost on a link connected to this port.
The configured priority of the port. The default is 128 or 0x80.
Indicates if the port is an operational Edge port. Edge ports may either be
auto-detected or configured (forced) to be Edge ports:
•
T – The port is and Edge port.
•
F – The port is not an Edge port. This is the default.
Indicates if the point-to-point-mac parameter is configured to be a
point-to-point link:
•
T – The link is a point-to-point link
•
F – The link is not a point-to-point link. This is the default.
Shows the following:
•
Root – Shows the ID of the root bridge for this bridge.
•
Bridge – Shows the ID of the Designated bridge that is associated with
this port.
"Bridges and bridge port roles"
"Bridge port states" on page 361 and
on page 362.
on page 357 for definitions of the
"Edge port and non-edge port
BigIron RX Series Configuration Guide
53-1002253-01