Dell PowerConnect B-RX Configuration Manual page 245

Syntax: show ip interface tunnel <tunnel-no>
This display shows the following information.
TABLE 45
This field...
Interface
IP-Address
OK?
Method
Status
Protocol
VRF
The show ip route command displays routes that are pointing to a GRE tunnel as shown in the
following.
BigIron RX# show ip route
Total number of IP routes: 9
Type Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/Metric
1
2
3
4
5
6
7
8
9
The show interface tunnel command displays the status and configuration information for a tunnel
interface as shown in the following.
BigIron RX# show interface tunnel 1
Syntax: show interface tunnel <number>
The <number> parameter indicates the tunnel interface number for which you want to display
information.
BigIron RX Series Configuration Guide
53-1002253-01
CLI display of interface IP configuration information
Displays...
The tunnel and tunnel number.
The IP address of the tunnel interface.
Whether the IP address has been configured on the tunnel interface.
Whether the IP address has been saved in NVRAM. If you have set the IP address
for the interface in the CLI, but have not saved the configuration, the entry for the
interface in the Method field is "manual".
The link status of the interface. If you have disabled the interface with the
disable command, the entry in the Status field will be "administratively down".
Otherwise, the entry in the Status field will be either "up" or "down".
Whether the interface can provide two-way communication. If the IP address is
configured, and the link status of the interface is up, the entry in the protocol
field will be "up". Otherwise the entry in the protocol field will be "down".
The name of the Virtual Routing instance that the tunnel is configured in.
Destination Gateway
2.2.2.1/32 DIRECT
10.10.1.0/24 110.110.2.12
20.2.1.0/24 DIRECT
45.4.1.0/24 80.8.1.2
63.148.1.0/24 DIRECT
70.7.1.0/24 DIRECT
80.8.1.0/24 70.7.1.1
110.110.2.0/24 63.148.1.1
189.100.1.0/24 110.110.2.12
Tunnel1 is up, line protocol is up
Hardware is Tunnel
Tunnel source 63.148.1.2
Tunnel destination is 110.110.2.12
Tunnel mode gre ip
Tunnel loopback is 1/3
No port name
MTU 1476 Bytes
Configuring IP parameters
Port Cost Type
loopback1 0/0 D
tunnel 1 1/1 S
eth5/11 0/0 D
tunnel 2 0/0 D
eth 2/11 0/0 D
eth 2/14 0/0 D
eth 2/14 1/1 S
eth 2/11 1/1 S
tunnel 1 0/0 D
7
169