Dell PowerConnect B-RX Configuration Manual page 1184

43
Displaying global IPv6 information
BigIron RX# show ipv6 interface
Routing Protocols : R - RIP
Interface
Ethernet 3/3
Ethernet 3/5
Ethernet 3/17
Ethernet 3/19
VE 4
VE 14
Loopback 1
Loopback 2
Loopback 3
Syntax: show ipv6 interface [<interface> [<port-number> |<number>]]
The <interface> parameter displays detailed information for a specified interface. For the interface,
you can specify the Ethernet, loopback, tunnel, or VE keywords. If you specify an Ethernet interface,
also specify the port number associated with the interface. If you specify a loopback, tunnel, or VE
interface, also specify the number associated with the interface.
This display shows the following information.
TABLE 175
This field...
Routing protocols
Interface
Status
Routing
Global Unicast Address
To display detailed information for a specific interface, enter a command such as the following at
any CLI level.
1108
O - OSPF I - ISIS
Status Routing
down/down R
down/down
up/up
up/up
down/down
up/up
up/up
up/up
up/up
General IPv6 interface information fields
Displays...
A one-letter code that represents a routing protocol that can be enabled
on an interface.
The interface type, and the port number or number of the interface.
The status of the interface. The entry in the Status field will be either
"up/up" or "down/down".
The routing protocols enabled on the interface.
The global unicast address of the interface.
Global Unicast Address
2017::c017:101/64
2019::c019:101/64
2024::c060:101/64
::1/128
2005::303:303/128
BigIron RX Series Configuration Guide
53-1002253-01