Displaying Summary Bgp4 Information - Dell PowerConnect B-RX Configuration Manual

Displaying summary BGP4 information

You can display the local AS number, the maximum number of routes and neighbors supported,
and some BGP4 statistics.
To view summary BGP4 information for the router, enter the following command at any CLI prompt.
BigIron RX# show ip bgp summary
BGP4 Summary
Router ID: 101.0.0.1
Confederation Identifier : not configured
Confederation Peers: 4 5
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 11, UP:2
Number of Routes Installed : 2
Number of Routes Advertising to All Neighbors : 8
Number of Attribute Entries Installed : 6
Neighbor Address
1.2.3.4
10.0.0.2
10.1.0.2
10.2.0.2
10.3.0.2
10.4.0.2
10.5.0.2
10.7.0.2
100.0.0.1
102.0.0.1
150.150.150.150
Syntax: show ip bgp summary
This display shows the following information.
TABLE 124
This field...
Router ID
Local AS Number
Confederation Identifier
Confederation Peers
Maximum Number of Paths Supported
for Load Sharing
Number of Neighbors Configured
Number of Routes Installed
Number of Routes Advertising to All
Neighbors
BigIron RX Series Configuration Guide
53-1002253-01
Local AS Number : 4
AS# State
200 ADMDN
5 ADMDN
5 ESTAB
5 ESTAB
5 ADMDN
5 ADMDN
5 CONN
5 ADMDN
4 ADMDN
4 ADMDN
0 ADMDN
BGP4 summary information
Displays...
The device's router ID.
The BGP4 AS number the router is in.
The AS number of the confederation the device is in.
The numbers of the local ASs contained in the confederation. This list
matches the confederation peer list you configure on the device.
The maximum number of route paths across which the device can
balance traffic to the same destination. The feature is enabled by
default but the default number of paths is 1. You can increase the
number from 2 – 8 paths. Refer to
shared BGP4 paths"
The number of BGP4 neighbors configured on this device, and currently
in established state.
The number of BGP4 routes in the router's BGP4 route table.
To display the BGP4 route table, refer to
table"
The total of the RtSent and RtToSend columns for all neighbors.
Displaying BGP4 information
Time Rt:Accepted Filtered Sent
0h44m56s 0
0h44m56s 0
0h44m56s 1
0h44m55s 1
0h25m28s 0
0h25m31s 0
0h 0m 8s 0
0h44m56s 0
0h44m56s 0
0h44m56s 0
0h44m56s 0
"Changing the maximum number of
on page 769.
on page 841.
ToSend
0 0 2
0 0 0
11 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 2
0 0 2
0 0 2
"Displaying the BGP4 route
26
825