Interface - Dell PowerConnect B-RX Configuration Manual

Displaying information on MAC address filters and IP ACLs on an

interface

You can display information about the user-defined and dynamically applied MAC address filters
and IP ACLs currently active on an interface.
Displaying MAC address filters applied to an 802.1x-enabled port
Use the show dot1x mac-address command to display information about MAC filters applied to an
interface. If the MAC address filter is dynamically assigned by 802.1x, the display shows the
following.
BigIron RX#show dot1x mac-address ethernet 1/1
Port 1/1 MAC Address Filter information:
802.1x dynamic MAC Filter (user defined) :
Port default MAC Filter :
The "Port default MAC Filter" appears if a default MAC filter has been configured on the port. This
default MAC filter is the MAC filter that will be applied to the port once the dynamically assigned
MAC filter is removed. If a default MAC filter has not been configured, the message "No Port default
MAC is displayed.
When the dynamically assigned MAC address filter is removed, the display shows the following
information.
BigIron RX#show dot1x mac-address ethernet 1/1
Port 1/1 MAC Address Filter information:
Port default MAC Filter :
Syntax: show dot1x mac-address-filter [all | ethernet <slot/port> | | begin <expression> |
The all keyword displays all dynamically applied MAC address filters active on the device.
Use the ethernet <slot>/<port> parameter to display information for one port.
Displaying IP ACLs applied to an 802.1x-enabled port
Use the show dot1x ip-acl command to display the information about what IP ACLs have been
applied to an 802.1x-enabled port. If the IP ACL was dynamically applied by 802.1x, the following
information is displayed.
BigIron RX#show dot1x ip-acl ethernet 1/1
Port 1/1 IP ACL information:
802.1x dynamic IP ACL (user defined) in:
Port default IP ACL in:
No outbound ip access-list is set
The "Port default IP ACL" appears if a default IP ACL has been configured on the port. The default IP
ACL is the IP ACL that will be applied to the port once the dynamically assigned IP ACL is removed.
If a default IP ACL has not been configured, the message "No Port default IP ACL" is displayed.
BigIron RX Series Configuration Guide
53-1002253-01
mac access-list 401 in
mac access-list 400 in
mac access-list 400 in
exclude <expression> | include <expression>]
ip access-list extended Port_1/1_E_IN in
ip access-list 100 in
Displaying 802.1x information
33
987