Dell PowerConnect B-RX Configuration Manual page 249

TABLE 47
This field...
Tunnel source
Tunnel destination
Tunnel mode
Port name
MTU
Displaying interface level IPv6 settings
To display Interface level IPv6 settings for tunnel interface 1, enter the following command at any
level of the CLI.
BigIron RX#show ipv6 inter tunnel 1
Interface Tunnel 1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::3:4:2 [Preferred]
Global unicast address(es):
Joined group address(es):
MTU is 1480 bytes
ICMP redirects are enabled
No Inbound Access List Set
No Outbound Access List Set
OSPF enabled
The display command above reflects the following configuration.
BigIron RX#show running-config interface tunnel 1
!
interface tunnel 1
port-name ManualTunnel1
tunnel mode ipv6ip
tunnel source loopback 1
tunnel destination 2.1.1.1
ipv6 address fe80::3:4:2 link-local
ipv6 address 1011::1/64
ipv6 address 1001::1/64
ipv6 ospf area 0
BigIron RX Series Configuration Guide
53-1002253-01
IPv6 tunnel interface information (Continued)
1001::1 [Preferred],
1011::1 [Preferred],
ff02::1:ff04:2
ff02::5
ff02::1:ff00:1
ff02::2
ff02::1
Displays...
The tunnel source can be one of the following:
•
An IPv4 address
•
The IPv4 address associated with an interface or port.
The tunnel destination can an IPv4 address.
The tunnel mode can be one the following:
•
ipv6ip auto-tunnel – Indicates an automatic IPv4-compatible tunnel.
•
ipv6ip 6to4 – Indicates an automatic 6to4 tunnel.
The port name configured for the tunnel interface.
The setting of the IPv6 maximum transmission unit (MTU).
subnet is 1001::/64
subnet is 1011::/64
Configuring IP parameters
7
173