Dell PowerConnect B-RX Configuration Manual page 469

BigIron RX(config)#show rstp vlan 10
VLAN 10 - RSTP instance 0
--------------------------------------------------------------------
RSTP (IEEE 802.1w) Bridge Parameters:
Bridge
Identifier
hex
0001000480a04000 20
RootBridge
Identifier
hex
0001000480a04000 0
RSTP (IEEE 802.1w) Port Parameters:
Port
Num
1/3
1/13
Syntax: show rstp [vlan <vlan-id>]
The vlan <vlan-id> parameter displays RSTP information for the specified port-based VLAN.
The show RSTP display command shows the information listed in
TABLE 80
This field...
VLAN ID
Bridge IEEE RSTP parameters
Bridge Identifier
Bridge Max Age
Bridge Hello
Bridge FwdDly
Force-Version
txHoldCnt
Root bridge parameters:
Root Bridge Identifier
Root Path Cost
BigIron RX Series Configuration Guide
53-1002253-01
Bridge Bridge Bridge Force
MaxAge Hello
sec sec
2
RootPath
Cost
<--- Config Params -->|<-------------- Current state ----------------->
Pri PortPath P2P Edge Role
Cost Mac Port
128 20000 T F
128 20000 T F
CLI display of RSTP summary
Displaying RSTP information
tx
FwdDly Version Hold
sec cnt
15 Default 3
DesignatedBridge Root
Identifier Port
hex
0001000480a04000 Root
State
DISABLED DISABLED
DISABLED DISABLED
Displays...
The port-based VLAN that owns the STP instance and the number of RSTP
instances on that VLAN. VLAN 1 is the default VLAN. If you have not
configured port-based VLANs on this device, all RSTP information is for
VLAN 1.
The ID of the bridge.
The configured max age for this bridge. The default is 20.
The configured hello time for this bridge.The default is 2.
The configured forward delay time for this bridge. The default is 15.
The configured force version value. One of the following values is displayed:
•
0 – The bridge has been forced to operate in an STP compatibility
mode.
•
2 – The bridge has been forced to operate in an RSTP mode. (This is
the default.)
The number of BPDUs that can be transmitted per Hello Interval. The
default is 3.
ID of the Root bridge that is associated with this bridge
The cost to reach the root bridge from this bridge. If the bridge is the root
bridge, then this parameter shows a value of zero.
Max Hel Fwd
Age lo Dly
sec sec sec
20 2 15
Designa- Designated
ted cost bridge
0 0000000000000000
0 0000000000000000
Table 80.
13
393