Dell PowerConnect B-RX Configuration Manual page 985

TABLE 145
This field...
Interface
Holddown
Interval
RH
To display BFD Neighbor information in the detailed format use the following command.
BigIron RX# show bfd neighbor details
Total number of Neighbor entries: 1
NeighborAddress
12.14.1.1
Registered Protocols: ospf
Local: Disc: 1, Diag: 0, Demand: 0 Poll: 0
Remote: Disc: 22, Diag: 7, Demand: 0 Poll: 0
Stats: RX: 72089 TX: 72101 SessionUpCount: 1 at SysUpTime: 0:1:30:54.775
Session Uptime: 0:1:30:6.375, LastSessionDownTimestamp: 0:0:0:0.0
Physical Port: eth 4/1, Vlan Id: 50
Syntax: show bfd neighbor details [IpAddress | IPv6Address]
This display shows the following information.
TABLE 146
This field...
Total number of Neighbor entries
NeighborAddress
State
Interface
Holddown
Interval
RH
Registered Protocols
Local
BigIron RX Series Configuration Guide
53-1002253-01
Displaying Bidirectional Forwarding Detection information
Display of BFD information (Continued)
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
Display of BFD neighbor detail information
Disc
Displays...
The logical port (physical or virtual port) on which the peer is known. The
physical port can be either Ethernet or POS.
The interval after which the session will transition to the down state if no
message is received.
The negotiated interval at which the local router sends BFD messages to the
remote peer.
Heard from remote.
State
UP
Displays...
Total number of BFD sessions.
IPv4 or IPv6 address of the remote peer.
The current state of the BFD session.
Up
Down
A.DOWN – The administrative down state.
INIT – The Init state.
UNKNOWN – The current state is unknown.
The logical port on which the peer is known.
The interval after which the session will transition to the down state if no
message is received.
The interval at which the local router sends BFD messages to the remote
peer.
Heard from remote.
Specifies which protocols are registered to use BFD on this port.
Value of the "local discriminator" field in the BFD Control Message as
used by the local router in the last message sent.
Interface Holddown Interval
ve 50 300000 100000
29
RH
1
909