Configuring Mrp - Dell PowerConnect B-RX Configuration Manual

14

Configuring MRP

If you use a topology group:
•
•
•
For more information about topology groups, refer to
Refer to
the MRP configuration shown in
Configuring MRP
To configure MRP, perform the following tasks. You need to perform the first task on only one of the
nodes. Perform the remaining tasks on all the nodes:
•
•
•
•
NOTE
When MRP and UDLD are running together, Brocade recommends keeping the MRP preforwarding
interval slightly higher than default(300ms) to 400 or 500ms to prevent the possibility of a
temporary loop of a few milliseconds.
410
The master VLAN must contain the ring interfaces. The ports must be tagged, since they will
be shared by multiple VLANs.
The member VLAN for a customer must contain the two ring interfaces and the interfaces for
the customer. Since these interfaces are shared with the master VLAN, they must be tagged.
Do not add another customer's interfaces to the VLAN.
When configuring a topology group on a port, note the following:
•
A topology group must be configured before configuring a Layer 2 protocol in the master
VLAN.
•
The port should be disabled before configuring a topology group on that port.
•
There should not be traffic on the port before configuring a topology group on that port.
"MRP CLI example" on page 421 for the configuration commands required to implement
Disable one of the ring interfaces. This prevents a Layer 2 loop from occurring while you are
configuring the devices for MRP.
Add an MRP ring to a port-based VLAN. When you add a ring, the CLI changes to the
configuration level for the ring, where you can do the following:
•
Optionally, specify a name for the ring.
•
On the master node only, enable the device to be the master for the ring. Each ring can
have only one master node.
•
Specify the MRP interfaces. Each device has two interfaces to an MRP ring.
•
Optionally, change the hello time and the preforwarding time. These parameters control
how quickly failover occurs following a change in the state of a link in the ring.
•
Enable the ring.
Optionally, add the ring's VLAN to a topology group to add more VLANs to the ring. If you use a
topology group, make sure you configure MRP on the group's master VLAN. Refer to
16, "Topology Groups".
Re-enable the interface you disabled to prevent a Layer 2 loop. Once MRP is enabled, MRP will
prevent the Layer 2 loop.
Chapter 16, "Topology
Figure 69.
Groups".
Chapter
BigIron RX Series Configuration Guide
53-1002253-01