Displaying Ip Interface Information - Dell PowerConnect B-RX Configuration Manual

TABLE 51
This field...
Port
Operator

Displaying IP interface information

To display IP interface information, enter the following command at any CLI level.
BigIron RX(config)# show ip interface
Interface
Ethernet 1/1
Ethernet 1/2
Loopback 1
Syntax: show ip interface [ethernet <slot/port>] | [loopback <num>] | [ve <num>]
This display shows the following information.
TABLE 52
This field...
Interface
IP-Address
OK?
Method
Status
Protocol
To display detailed IP information for a specific interface, enter a command such as the following.
BigIron RX Series Configuration Guide
53-1002253-01
CLI display of global IP configuration information (Continued)
Displays...
The Layer 4 TCP or UDP port the policy checks for in packets. The port can
be displayed by its number or, for port types the router recognizes, by the
well-known name. For example, TCP port 80 can be displayed as HTTP.
NOTE: This field applies only if the IP protocol is TCP or UDP.
The comparison operator for TCP or UDP port names or numbers.
NOTE: This field applies only if the IP protocol is TCP or UDP.
IP-Address
207.95.6.173
3.3.3.3
1.2.3.4
CLI display of interface IP configuration information
Displays...
The type and the slot and port number of the interface.
The IP address of the interface.
NOTE: If an "s" is listed following the address, this is a secondary address.
Whether the IP address has been configured on the interface.
Whether the IP address has been saved in NVRAM. If you have set the IP
address for the interface in the CLI, but have not saved the configuration,
the entry for the interface in the Method field is "manual".
The link status of the interface. If you have disabled the interface with the
disable command, the entry in the Status field will be "administratively
down". Otherwise, the entry in the Status field will be either "up" or "down".
Whether the interface can provide two-way communication. If the IP address
is configured, and the link status of the interface is up, the entry in the
protocol field will be "up". Otherwise the entry in the protocol field will be
"down".
Displaying IP information
OK? Method Status
YES NVRAM up
YES manual up
YES NVRAM down
When the address was configured, the interface already had an IP
address in the same subnet, so the software required the
"secondary" option before the software could add the interface.
7
Protocol
up
up
down
223