Dell PowerConnect B-RX Configuration Manual page 984

29
Displaying Bidirectional Forwarding Detection information
TABLE 143
This field...
Mult
Sessions
Displaying BFD application information
The following example illustrates the output from the show bfd application command.
BigIron RX# show bfd application
Registered Protocols Count: 3
This display shows the following information.
TABLE 144
This field...
Parameter
Displaying BFD neighbor information
The following example illustrates the output from the show bfd neighbor command.
BigIron RX# show bfd neighbor
Total number of Neighbor entries: 2
NeighborAddress
12.14.1.1
12.2.1.1
Syntax: show bfd neighbor [interface ethernet <slot/port> | interface pos <slot/port> | interface
The interface ethernet option displays BFD neighbor information for the specified ethernet
interface only.
The interface ve option displays BFD neighbor information for the specified virtual interface only.
This display shows the following information.
TABLE 145
This field...
Total number of Neighbor entries
NeighborAddress
State
908
Display of BFD information (Continued)
Protocol Parameter
ospf
ospf6
isis_task
Display of BFD application information
ve <port-no>]
Display of BFD information
this router.
Displays...
The number of times that the router will wait for the MinRx time on this
port before it determines that its peer router is non-operational.
The number of BFD sessions originating on this port.
1
0
0
Displays...
The parameter value passed by the protocol during registration with BFD.
State
UP
UP
Displays...
The number of neighbors that have established BFD sessions with ports on
The IPv4 or IPv6 address of the remote peer.
The current state of the BFD session.
Up - Up
Down - Down
A.DOWN – The administrative down state.
INIT – The Init state.
UNKNOWN – The current state is unknown.
Interface Holddown Interval
eth 3/1 300000 100000
eth 2/1 300000 100000
BigIron RX Series Configuration Guide
RH
1
1
53-1002253-01