Hub Configuration - Dell PowerConnect B-RX Configuration Manual

Hub configuration

Figure 130
which is connected to a port on the BigIron RX device. The configuration is similar to that in
Figure
command is used to allow multiple Clients on the port.
FIGURE 130
The following commands configure the BigIron RX in
BigIron RX(config)# aaa authentication dot1x default radius
BigIron RX(config)# radius-server host 192.168.9.22 auth-port 1812 acct-port 1813
default key mirabeau dot1x
BigIron RX(config)# dot1x-enable e 2/1
BigIron RX(config-dot1x)# re-authentication
BigIron RX(config-dot1x)# timeout re-authperiod 2000
BigIron RX(config-dot1x)# timeout quiet-period 30
BigIron RX(config-dot1x)# timeout tx-period 60
BigIron RX(config-dot1x)# max-req 6
BigIron RX(config-dot1x)# exit
BigIron RX(config)# interface e 2/1
BigIron RX(config-if-e100-1)# dot1x port-control auto
BigIron RX(config-if-e100-1)# exit
BigIron RX Series Configuration Guide
53-1002253-01
illustrates a configuration where three 802.1x-enabled Clients are connected to a hub,
129, except that 802.1x port security is enabled on only one port, and the multiple-hosts
Sample 802.1x configuration using a hub
Clients/Supplicants running 802.1X-compliant client software
Sample 802.1x configurations
RADIUS Server
(Authentication Server)
192.168.9.22
BigIron Device
(Authenticator)
e2/1
Hub
Figure 130.
33
991