Displaying Ospf Trap Status; Displaying Ospf Virtual Neighbor And Link Information - Dell PowerConnect B-RX Configuration Manual

25
Displaying OSPF information
TABLE 119
This field...
(Index)
Router ID
Router type
Next hop router
Outgoing interface
Area

Displaying OSPF trap status

All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, refer
to "Modifying OSPF traps generated"
To display the state of each OSPF trap, enter the following command at any CLI level.
BigIron RX># show ip ospf trap
Interface State Change Trap:
Virtual Interface State Change Trap:
Neighbor State Change Trap:
Virtual Neighbor State Change Trap:
Interface Configuration Error Trap:
Virtual Interface Configuration Error Trap:
Interface Authentication Failure Trap:
Virtual Interface Authentication Failure Trap:
Interface Receive Bad Packet Trap:
Virtual Interface Receive Bad Packet Trap:
Interface Retransmit Packet Trap:
Virtual Interface Retransmit Packet Trap:
Originate LSA Trap:
Originate MaxAge LSA Trap:
Link State Database Overflow Trap:
Link State Database Approaching Overflow Trap:
Syntax: show ip ospf trap

Displaying OSPF virtual neighbor and link information

You can display OSPF virtual neighbor and virtual link information. For example, the following show
run display shows the configuration in
BigIron RX#show run
Current configuration:
!
ver V2.2.1T143
module 1 rx-bi-1g-24-port-fiber
module 2 rx-bi-10g-4-port
module 6 rx-bi-10g-4-port
module 7 rx-bi-1g-24-port-copper
!
!
no spanning-tree
!
732
CLI display of OSPF border routers
Displays...
Displayed index number of the border router.
ID of the OSPF router
Type of OSPF router: ABR or ASBR
ID of the next hop router
ID of the interface on the router for the outgoing route.
ID of the OSPF area to which the OSPF router belongs
on page 716.
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Figure 109.
BigIron RX Series Configuration Guide
53-1002253-01