Next Hop Validation Check; Pim Dense - Dell PowerConnect B-RX Configuration Manual

To add a static route to a virtual interface, enter commands such as the following.
BigIron RX(config)# ip mroute 0.0.0.0 0.0.0.0 int ve 1 distance 1
BigIron RX(config)# write memory

Next hop validation check

You can configure the BigIron RX to perform multicast validation checks on the destination MAC
address, the sender and target IP addresses, and the source MAC address.
You can enable ARP validation check on the global basis. When feature is enabled, the multicast
route will only be installed when the next hop ARP has been resolved.
Configuring an ARP validation check
To enable the ARP validation check globally, enter a command such as the following.
BigIron RX(config)#ip mroute validate-nexthop-arp
Syntax: [no] ip mroute validate-nexthop-arp
Use the no form of the command to disable the ARP validation feature. When ARP validation is
disabled, The static mroute will be installed without checking the validity of the next hop.
Enabling the next hop validate ARP timer
The ip arp validate-nexthop-timer command has been introduced which replaces the ip route
validate-nexthop-arp-timer and the ip mroute validate-nexthop-arp-timer commands. The next hop
validate ARP timer works only on the ARP entries created when the ARP validation check feature
has been enabled. The timer is used to age out the ARP entries when the next hop goes down. All
other ARP entries in the system, which are NOT created due to static routes, follow the normal ARP
age timer with default value of 3 minutes.
Use the validation timer to reduce the response time where the static route with the next hop down
can be replaced quickly with a route with active next hop.
To set the validation timer to 30 seconds, enter commodes such as the following.
BigIron RX(config)#ip arp validate-nexthop-timer 30
Syntax: [no] ip arp validate-nexthop-timer <value>
The default is 200 seconds.
The value parameter specifies the amount of time before a nexthop down is replaced by an active
nexthop. Possible values are10-200 seconds.
Use the no form of the command to disable the validation timer.

PIM dense

NOTE
This section describes the "dense" mode of PIM, described in RFC 1075. Refer to
page 605 for information about PIM Sparse.
BigIron RX Series Configuration Guide
53-1002253-01
23
PIM dense
"PIM Sparse" on
597