From Named Acls - Dell PowerConnect B-RX Configuration Manual

The <acl-number> parameter specifies the ACL entry to be deleted. The <acl-num> parameter
allows you to specify an ACL number if you prefer. If you specify a number, enter a number from 1 –
99 for standard ACLs, 100 – 199 for extended ACLs, or 500 – 599 for super ACLs.
You must enter the complete deny or permit statement for the <entire-deny-or-permit-statement>
variable.
Complete the configuration by specifying options for the ACL entry. Options you can use to
configure standard or extended numbered ACLs are discussed in
ACLs"
to configure super ACLs are described in

From named ACLs

To delete an ACL entry from an ACL named "entry", do the following.
1. Enter the following command to display the contents of the ACL list.
2. To delete the second ACL entry from the list, enter a command such as the following.
3. Enter the show access-list name entry command to display the updated list.
Syntax: ip access-list standard | extended <acl-name> | <acl-number>
Syntax: no <entire-deny-or-permit-statement>
The extended | standard parameter indicates the ACL type.
The <acl-name> parameter is the ACL name. You can specify a string of up to 255 alphanumeric
characters. You can use blanks in the ACL name if you enclose the name in quotation marks (for
example, "ACL for Net1"). The <acl-num> parameter allows you to specify an ACL number if you
prefer. If you specify a number, enter a number from 1 – 99 for standard ACLs or 100 – 199 for
extended ACLs. Super ACLs must always be numbered instead of named, from 500 – 599.
You must enter the complete deny or permit statement for the <entire-deny-or-permit-statement>
variable.
BigIron RX Series Configuration Guide
53-1002253-01
on page 529 and "Configuring extended numbered ACLs"
BigIron RX#show access-list name entry
Standard IP access list entry
deny host 1.2.4.5
deny host 10.1.1.1
deny host 5.6.7.8
permit any
BigIron RX(config)#ip access-list standard entry
BigIron RX(config-std-nacl)#no deny host 10.1.1.1
BigIron RX(config)# ip show access entry all
Standard IP access list entry
deny host1.2.4.5
deny host 5.6.7.8
permit any
"Configuring standard numbered
on page 531. Options you can use
"Configuring super ACLs"
Deleting ACL entries
on page 542.
21
561