How Wred Operates; Calculating Avg-Q-Size; Calculating Packets That Are Dropped - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

18
Determining packet drop priority using WRED

How WRED Operates

The graph in
operation of WRED. When a packet arrives at a switch, the average queue size (q-size) is calculated
(note that this is not the statistical average queue size - (refer to
page 488). If q-size as calculated is below the configured Min. Average Queue Size, then the packet
is accepted. If the average queue size is above the configured Max. Average Queue Size threshold,
the packet is dropped. If the Average Queue size falls between the Min. Average Queue Size and
the Max. Average Queue Size, packets are dropped according to the calculated probability
described in
FIGURE 88

Calculating avg-q-size

The algorithm first calculates the avg-q-size through the following equation.
avg-q-size = ( (1 - Wq) * Statistical Average-Q-Size) + (Wq * Current-Q-Size)
The Wq value is instrumental to the calculation and can be:
Lower Wq values cause the avg-q-size to lean towards the statistical average queue size, reducing
WRED's sensitivity to the current state of the queue and thus reduce WRED's effectiveness. On the
other hand, higher Wq values cause the avg-q-size to lean towards the instantaneous queue size,
which exposes WRED to any change in the instantaneous queue size and thus may cause WRED to
overreact in cases of bursts. Thus, the value of Wq should be carefully chosen according to the
application at hand.

Calculating packets that are dropped

The Pdrop value, as calculated in the following equation, is the probability that a packet will be
dropped in a congested switch.
488
Figure 88
describes the interaction of the previously described variables in the
"Calculating packets that are dropped"
WRED operation graph
Pmax
equal to the statistical average queue size (Wq == 0), or
equal to the current queue size (Wq == 1) or
be between 0 and 1 (0 < Wq < 1).
"Calculating avg-q-size"
on page 488.
Min. Average
Max. Average
Queue Size
Queue Size
BigIron RX Series Configuration Guide
on
53-1002253-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents