Dell PowerConnect B-RX Configuration Manual page 369

•
•
Configuring VLAN byte accounting
To enable VLAN accounting on a specified VLAN, use the following commands.
BigIron RX(config)# vlan 10
BigIron RX(config-vlan-10)# byte-accounting
Syntax: [no] byte-accounting
Displaying VLAN byte accounting information
To display VLAN accounting information for all VLANs configured on a router, use the show vlan
command as shown.
BigIron RX# show vlan
Configured PORT-VLAN entries: 2
Maximum PORT-VLAN entries: 512
Default PORT-VLAN id: 1
PORT-VLAN 1, Name DEFAULT-VLAN, Priority Level0
L2 protocols : NONE
Untagged Ports : ethe 1/1 to 1/40 ethe 2/1 to 2/4
PORT-VLAN 10, Name [None], Priority Level0
L2 protocols
Tagged Ports
Bytes received : 18527
To display VLAN accounting information for a specific VLAN, use the show vlan <vlan> command as
shown.
BigIron RX# show vlan 10
PORT-VLAN 10, Name [None], Priority Level0
L2 protocols
Tagged Ports
Bytes received : 5626
The Bytes received field displays the number of bytes received by all member ports of all VLANs
configured on the router.
Maximum number of rate limiting policies and VLANs with byte accounting
The maximum number of ACL-based, and VLAN-based rate limiting policies that can be configured
on ports controlled by the same packet processor also depends on the number of VLANs with byte
accounting enabled on the same packet processor.
On a given packet processor (PPCR), the total of:
BigIron RX Series Configuration Guide
53-1002253-01
If a port's VLAN has byte accounting enabled, you cannot enable rate limiting on that port.
Similarly, if a port has rate limiting enabled, you cannot enable VLAN byte accounting on that
port's VLAN.
Clearing the rate limiting counters using clear rate-limit counters will also clear VLAN
byte-accounting counters. It is recommended that when using rate limiting along with VLAN
byte accounting, use individual port rate limiting counters.
: NONE
: ethe 1/2 to 1/5
: NONE
: ethe 1/2 to 1/5
Number of VLANs with byte accounting enabled
+
Number of rate limiting policies based on ACLs and VLANs
cannot exceed the maximum number of policies as specified in
Configuring port-based VLANs
Table 64.
11
293