Displaying The Forwarding Cache - Dell PowerConnect B-RX Configuration Manual

7
Displaying IP information
TABLE 53
This field...
Age
Port
Displaying the static ARP table
To display the static ARP table, enter the following command at any CLI level.
BigIron RX# show ip static-arp
Static ARP table size: 512, configurable from 512 to 1024
Index
1
3
This example shows two static entries. Note that since you specify an entry's index number when
you create the entry, it is possible for the range of index numbers to have gaps, as shown in this
example. The entry number you assign to a static ARP entry is not related to the entry numbers in
the ARP cache.
Syntax: show ip static-arp [ethernet <slot>/<portnum> | mac-address <xxxx.xxxx.xxxx> [<mask>]
For information on the command syntax, refer to the syntax of the show arp command under
"Displaying the ARP cache"
TABLE 54
This field...
Static ARP table size
Index
IP Address
MAC Address
Port

Displaying the forwarding cache

To display the IP Forwarding Cache for directly connected hosts, enter the following command.
226
CLI display of ARP cache (Continued)
Displays...
The number of minutes the entry has remained unused. If this value
reaches the ARP aging period, the entry is removed from the table.
To display the ARP aging period, refer to
information"
"Changing the ARP aging period"
NOTE: Static entries do not age out.
The port on which the entry was learned.
IP Address
207.95.6.111
207.95.6.123
|
<ip-addr> [<ip-mask>]] [<num>] [| begin <expression> | exclude <expression> | include
<expression>]
on page 224.
CLI display of static ARP table
Displays...
The maximum number of static entries that can be configured on the device
using the current memory allocation. The range of valid memory allocations
for static ARP entries is listed after the current allocation. To change the
memory allocation for static ARP entries, refer to
number of entries the static ARP table can hold"
The number of this entry in the table. You specify the entry number when
you create the entry.
The IP address of the device.
The MAC address of the device.
The port attached to the device the entry is for.
on page 221. To change the ARP aging interval, refer to
on page 190.
MAC Address Port
0800.093b.d210 1/1
0800.093b.d211 1/1
"Displaying global IP configuration
"Changing the maximum
on page 191.
BigIron RX Series Configuration Guide
53-1002253-01