Dell PowerConnect B-RX Configuration Manual page 325

TABLE 58
This field...
Type
Deploy
Trunk
Primary
Port List
The following information is displayed per-LAG the show lag command for each LAG configured.
LAG configuration
Deployment
Port
Link
L2 State
Dupl
Speed
Trunk
Tag
Priori
MAC
Name
Sys P
Port P
Key
BigIron RX Series Configuration Guide
53-1002253-01
Show LAG information (Continued)
Ports
Primary Port:
LACP Key
Displays...
The configured type of the LAG: static, dynamic, or keep-alive
Status of LAG deployment:
Y – yes, LAG is deployed.
N – no, LAG is not deployed.
The trunk ID number.
The primary port of the LAG.
The list of ports that are configured in the LAG.
List of ports configured with the LAG.
The primary port configured on the LAG.
The link aggegation key for the LAG.
The Trunk ID number.
The slot and port number of the interface.
The status of the link which can be one of the following:
•
up
•
down
The L2 state for the port.
The duplex state of the port, which can be one of the following:
•
Full
•
Half
•
None
The bandwidth of the interface.
The Trunk ID of the port.
Indicates whether the ports have 802.1q VLAN tagging. The value can
be Yes or No.
Indicates the Quality of Service (QoS) priority of the ports. The priority
can be a value from 0 – 7.
The MAC address of the port.
The name (if any) configured for the port.
Lists the system priority configured for the device.
Lists the port's link aggregation priority.
Lists the link aggregation key.
8
Deploying a LAG
249