Clearing The Acl Statistics - Dell PowerConnect B-RX Configuration Manual

This field...
The IP multicast traffic snooping state
Collecting ACL accounting summary for
<interface>
Inbound ACL ID
#
Hit count
Syntax: show access-list accounting ethernet [<slot>/<port> | ve <ve-number>]
Use ethernet <slot>/<port> to display a report for a physical interface.
Use ve <ve-number> to display a report for the ports that are included in a virtual routing interface.
For example, if ports 1/2, 1/4, and 1/6 are all members of ve 2, the report includes information for
all three ports.
Use the in parameter to display statistics for incoming traffic.
The l2 parameter limits the display to Layer 2 ACL accounting information.
The policy-based-routing parameter limits the display to policy based routing accounting
information. This option is only available for incoming traffic.
The rate-limit parameter limits the display to rate limiting ACL accounting information.

Clearing the ACL statistics

Statistics on the ACL account report can be cleared:
•
•
•
BigIron RX(config)# clear access-list all
Syntax: clear access-list all | ethernet <slot>/<port> | ve <ve-num>
Enter all to clear all statistics for all ACLs.
Use ethernet <slot>/<port> to clear statistics for ACLs a physical port.
Use ve <ve-number> to clear statistics for all ACLs bound to ports that are members of a virtual
routing interface.
BigIron RX Series Configuration Guide
53-1002253-01
When a software reload occurs
When the ACL is bound to or unbound from an interface
When you enter the clear access-list command, as in the following example.
Displays...
The first line of the display indicates whether IP multicast traffic
snooping is enabled or disabled. If enabled, it indicates if the feature is
configured as passive or active.
Shows the interface included in the report and whether or not the
collection was successful.
Shows the direction of the traffic on the interface and the ID of the ACL
used.
Shows the index of the ACL entry, starting with 0, followed by the permit
or deny condition defined for that ACL entry. (The first entry created for
an ACL is assigned the index 0. The next one created is indexed as 1,
and so on.)
ACL entries are arranged beginning with the entry with the highest
number of hits for IPv4 ACLs. For all other options, ACL entries are
displayed in order of ascending ACL filter IDs.
Shows the number of hits for each counter.
21
ACL accounting
567