Displaying Lag Statistics - Dell PowerConnect B-RX Configuration Manual

TABLE 58
This field...
Def
Exp
Ope

Displaying LAG statistics

You can display LAG statistics for a BigIron RX switch in either a full or brief mode. Full mode is the
default and is displayed when the show statistics lag command is executed without the brief
option. The examples below show both options of the show statistics lag command.
BigIron RX# show statistics brief lag
LAG
OutErr]
BigIron RX# show statistics lag
LAG d1 Counters:
InBroadcastPkts
InMulticastPkts
BigIron RX Series Configuration Guide
53-1002253-01
Show LAG information (Continued)
Packets
[Receive
LAG d1 1173
LAG e 1268
InOctets
InPkts
InUnicastPkts
InDiscards
InErrors
InCollisions
Alignment
Displays...
Indicates whether the port is using default link aggregation values. The
port uses default values if it has not received link aggregation
information through LACP from the port at the remote end of the link.
This field can have one of the following values:
•
Def – The port has not received link aggregation values from the
port at the other end of the link and is therefore using its default
link aggregation LACP settings.
•
No – The port has received link aggregation information from the
port at the other end of the link and is using the settings negotiated
with that port.
Indicates whether the negotiated link aggregation settings have expired.
The settings expire if the port does not receive an LACPDU message
from the port at the other end of the link before the message timer
expires. This field can have one of the following values:
•
Exp – The link aggregation settings this port negotiated with the
port at the other end of the link have expired. The port is now using
its default link aggregation settings.
•
No – The link aggregation values that this port negotiated with the
port at the other end of the link have not expired, so the port is still
using the negotiated settings.
•
Ope (operational) - The port is operating normally.
•
Blo (blocked) - The port is blocked because the adjacent port is not
configured with link aggregation or because it is not able to join a
trunk group. An LACP port is blocked until it becomes part of a
trunk. Also, an LACP is blocked if its state becomes "default". To
unblock the port and bring it to an operational state, enable link
aggregation on the adjacent port and ensure that the ports have
the same key.
Collisions
Transmit]
1018
1277
127986 OutOctets
1149 OutPkts
0 OutBroadcastPkts
852 OutMulticastPkts
297 OutUnicastPkts
0 OutDiscards
0 OutErrors
0 OutCollisions
OutLateCollisions
0
Deploying a LAG
Errors
[Recv Txmit]
0 0 0
0 0 0
107753
996
684
312
FCS
8
[InErr
0
0
0
0
0
0
0
0
251