Displaying Acl Definitions - Dell PowerConnect B-RX Configuration Manual

21

Displaying ACL definitions

sp
dp
icmp-detail
801.2-priority-matching
ipsec-spi
qos-marking
dscp-marking
internal-priority-marking
tcp-flags
<icmp-type-code>
Parameters to bind super ACLs to an interface
Super ACLs can be applied to physical interfaces, trunk interfaces, and virtual interfaces. They
follow the same configuration constraints as the IPv4 ACLs, for example they cannot co-exist with
an IPv4 ACL on the same interface.
Syntax: [no] super-acl <num> in
Displaying ACL definitions
To display the ACLs configured on a device, use the show ip access-lists command.
Numbered ACL
For a numbered ACL, you can enter a command such as the following.
BigIron RX(config)#show access-list 99
ACL configuration:
!
Standard IP access list 10
access-list 99 deny host 10.10.10.1
access-list 99 permit any
Syntax: show access-list <number> | all
Enter the ACL number for the <number> parameter:
•
•
•
Enter all to display all of the ACLs configured on the device.
Named ACL
For a named ACL, enter a command such as the following.
544
Enables packet matching based on specified source TCP/UDP port.
Enables packet matching based on specified destination TCP/UDP port.
Enables packet matching based on ICMP information.
Enables packet matching based on the specified 802.1p priority value. Valid range
is 0-7.
This parameter filters packets based on their IPSEC Security Parameter Index (SPI).
Enter this value in hexadecimal. The range is 00000000 - fffffffff
Enables packet matching based on QoS marking.
Enables packet matching based on DSCP marking.
Enables packet matching based on internal priority marking.
Enables packet matching based on TCP flags.
Enables packet matching based on ICMP type/code.
1 – 99 for standard ACLs
100 – 199 for extended ACLs
500 – 599 for super ACLs
BigIron RX Series Configuration Guide
53-1002253-01