Displaying Lsp Database Entries - Dell PowerConnect B-RX Configuration Manual

TABLE 138
This field...
Cost
Type
Tag
Path
Next Hop IP
Interface
Flags

Displaying LSP database entries

Use the following methods to display summary or detailed information about the entries in the LSP
database.
NOTE
The BigIron RX maintains separate LSP databases for Level-1 LSPs and Level-2 LSPs.
Displaying summary information
To display summary information for all the LSPs in the device's LSP databases, enter the following
command at any level of the CLI.
BigIron RX)# show isis database
IS-IS Level-1 Link State Database
LSPID
RX-1.00-00
RX-1.01-00
RX-1.02-00
RX.00-00*
IS-IS Level-2 Link State Database
LSPID
RX-1.00-00
RX-1.01-00
RX-1.02-00
RX.00-00*
0000.0100.0003.00-00
0000.0100.0003.00-01
The command in this example shows information for the LSPS in the device's Level-1 and Level-2
LSP databases. Notice that the display groups the Level-1 and Level-2 LSPs separately.
Syntax: show isis database [<lsp-id> | detail | l1 | l2 | level1 | level2]
BigIron RX Series Configuration Guide
53-1002253-01
IS-IS route information (Continued)
Displays...
The IS-IS default metric for the route, which is the cost of using this route
to reach the next-hop router to this destination.
The route type, which can be one of the following:
•
•
The tag value associated with the route.
The path number in the table. The IS-IS route table can contain multiple
equal-cost paths to the same destination, in which case the paths are
numbered consecutively. When IP load sharing is enabled, the device
can load balance traffic to the destination across the multiple paths.
The IP address of the next-hop interface to the destination.
The device interface (port or virtual interface) attached to the next hop.
Values used by Brocade technical support for troubleshooting.
LSP Seq Num
0x0000000c
0x00000004
0x00000001
0x0000000b
LSP Seq Num
0x0000000d
0x00000004
0x00000001
0x0000000b
0x0000001f
0x0000001d
Displaying IPv4 IS-IS information
L1 – Level-1 route
L2 – Level-2 route
LSP Checksum LSP Holdtime
0xd048 963
0x09b0 957
0xc57b 961
0x23fb 1030
LSP Checksum LSP Holdtime
0x7d97 964
0x09b0 958
0x200f 962
0x5647 1030
0x761a 932
0x9c9d 606
28
ATT/P/OL
1/0/0
0/0/0
0/0/0
1/0/0
ATT/P/OL
1/0/0
0/0/0
0/0/0
1/0/0
0/0/0
0/0/0
897