Displaying Information About The Dot1X-Mac-Sessions On; Each Port - Dell PowerConnect B-RX Configuration Manual

33
Displaying 802.1x information
When the dynamically assigned IP ACL is removed from the port, the display shows the following
information.
BigIron RX#show dot1x ip-acl ethernet 1/1
Port 1/1 IP ACL information:
Port default IP ACL in:
No outbound ip access-list is set
Syntax: show dot1x ip-acl [all | ethernet <slot/port> | | begin <expression> | exclude
The all keyword displays all dynamically applied IP ACLs active on the device.
Use the ethernet <slot>/<port> parameter to display information for one port.

Displaying information about the dot1x-mac-sessions on

each port

To display information about the dot1x-mac-sessions on each port on the device, enter the
following command.
BigIron RX# show dot1x mac-session
Port
-------------------------------------------------------------------------------
1/1
1/2
1/3
1/4
1/5
Syntax: show dot1x mac-session [brief | [begin <expression> | exclude <expression> | include
Table 163
TABLE 163
This field...
Port
MAC
Username
Vlan
Auth-State
988
ip access-list 100 in
<expression> | include <expression>]
MAC Username
0050.da0b.8cd7 Mary M
0050.da0b.8cb3 adminmorn
0050.da0b.8bef reports
0010.5a1f.6a63 testgroup
0050.da1a.ff7e admineve
<expression>]]
describes the information displayed by the show dot1x mac-session command.
Output from the show dot1x mac-session command
Displays...
The port on which the dot1x-mac-session exists.
The MAC address of the Client
The username used for RADIUS authentication.
The VLAN to which the port is currently assigned.
The authentication state of the dot1x-mac-session. This can be one of
the following.
permit – The Client has been successfully authenticated, and traffic
from the Client is being forwarded normally.
blocked – Authentication failed for the Client, and traffic from the Client
is being dropped in hardware.
restricted – Authentication failed for the Client, but traffic from the Client
is allowed in the restricted VLAN only.
init - The Client is in is in the process of 802.1x authentication, or has
not started the authentication process.
VLAN Auth State ACL|MAC
i|o|f
1 DENIED n|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
4094 PERMITTED y|n|n
BigIron RX Series Configuration Guide
53-1002253-01
Age
0
0
0
0
0