Vsrp Fast Start - Dell PowerConnect B-RX Configuration Manual

15
Configuring optional VSRP parameters
BigIron RX(config-vlan-200-vrid-1)# ip-address 10.10.10.1
Syntax: [no] ip-address <ip-addr>

VSRP fast start

VSRP fast start allows non-Brocade or non-VSRP aware devices that are connected to a Brocade
device that is the VSRP Master to quickly switchover to the new Master when a VSRP failover
occurs
This feature causes the port on a VSRP Master to restart when a VSRP failover occurs. When the
port shuts down at the start of the restart, ports on the non-VSRP aware devices that are
connected to the VSRP Master flush the MAC address they have learned for the VSRP master. After
a specified time, the port on the previous VSRP Master (which now becomes the Backup) returns
back online. Ports on the non-VSRP aware devices switch over to the new Master and learn its MAC
address.
Configuring VSRP fast start
The VSRP fast start feature can be enabled on a VSRP-configured Brocade device, either on the
VLAN to which the VRID of the VSRP-configured device belongs (globally) or on a port that belongs
to the VRID.
To globally configure a VSRP-configured device to shut down its ports when a failover occurs, then
restart after five seconds, enter the following command.
BigIron RX(configure)#vlan 100
BigIron RX(configure-vlan-100)#vsrp vrid 1
BigIron RX(configure-vlan-100-vrid-1)#fast-start 5
Syntax: [no] fast-ports <seconds>
This command shuts down all the ports that belong to the VLAN when a failover occurs. All the
ports will have the specified VRID.
To configure a single port on a VSRP-configured device to shut down when a failover occurs, then
restart after a period of time, enter the following command.
BigIron RX(configure)#interface ethernet 1/1
BigIron RX(configure-if-1/1)#vsrp fast-start 5
Syntax: [no] vsrp fast-start <seconds>
In both commands, the <seconds> parameter instructs the VSRP Master to shut down its port for
the specified number of seconds before it starts back up. Enter a value between 1 – 120 seconds.
The default is 1 second.
Displaying ports that have the VSRP fast start feature enabled
The show vsrp vrid command shows the ports on which the VSRP fast start feature is enabled.
434 BigIron RX Series Configuration Guide
53-1002253-01