•
•
•
•
•
The tables you can configure as well the defaults and valid ranges for each table differ depending
on the device you are configuring.
NOTE
If you increase the number of subnet addresses you can configure on each port to a higher amount,
you might also need to increase the total number of subnets that you can configure on the device.
NOTE
Changing the table size for a parameter reconfigures the device's memory. Whenever you
reconfigure the memory on a device, you must save the change to the startup configuration file, then
reload the software to place the change into effect.
To display the configurable tables, their defaults and maximum values, enter the following
command at any level of the CLI.
BigIron RX Series Configuration Guide
53-1002253-01
Displaying and modifying system parameter default settings
ARP entries
IP routes
IP route filters
IP subnets per port and per device
Static routes
5
131