Dell PowerConnect B-RX Configuration Manual page 351

BigIron RX#show lldp statistics
Last neighbor change time: 23 hours 50 minutes 40 seconds ago
Neighbor entries added
Neighbor entries deleted
Neighbor entries aged out
Neighbor advertisements dropped : 0
Port
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Syntax: show lldp statistics
NOTE
You can reset LLDP statistics using the CLI command clear LLDP statistics. Refer to
statistics"
The following table describes the information displayed by the show lldp statistics command.
This field...
Last neighbor change
time
Neighbor entries added The number of new LLDP neighbors detected since the last reboot or since the last time
Neighbor entries
deleted
Neighbor entries aged
out
Neighbor
advertisements
dropped
Port
Tx Pkts Total
BigIron RX Series Configuration Guide
53-1002253-01
Tx Pkts Rx Pkts
Total Total
60963 75179
0 0
60963 60963
60963 121925
0 0
0 0
0 0
0 0
0 0
60974 0
0 0
0 0
0 0
0 0
on page 279.
Displays...
The elapsed time (in hours, minutes, and seconds) since a neighbor last advertised
information. For example, the elapsed time since a neighbor was last added, deleted, or
its advertised information changed.
the clear lldp statistics all command was issued. This number includes the number
entries added after timing out or aging out.
The number of LLDP neighbors deleted since the last reboot or since the last time the
clear lldp statistics all command was issued. This number includes the number of
entries deleted after timing out or aging out.
The number of LLDP neighbors dropped on all ports after the time-to-live expired.
Note that LLDP entries age out naturally when a port's cable or module is disconnected
or when a port becomes disabled. However, if a disabled port is re-enabled, the system
will delete the old LLDP entries.
The number of valid LLDP neighbors the device detected, but could not add. This can
occur, for example, when a new neighbor is detected and the device is already
supporting the maximum number of neighbors possible. This can also occur when an
LLDPDU is missing a mandatory TLV or is not formatted correctly.
The local port number.
The number of LLDP packets the port transmitted.
: 14
: 5
: 4
Rx Pkts Rx Pkts
w/Errors Discarded Unrecognz Discarded
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Configuring LLDP
Rx TLVs Rx TLVs Neighbors
Aged Out
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
"Resetting LLDP
9
4
0
0
0
0
0
0
0
0
0
0
0
0
0
275