14
Displaying MRP information
Displaying ring information
To display ring information, enter the following command.
BigIron RX(config)# show metro
Metro Ring 2
=============
Ring
id
2
Ring interfaces
Interface Type
ethernet 1/1
Regular
ethernet 1/2
RHPs sent
3
Syntax: show metro [<ring-id>]
This display shows the following information.
TABLE 84
This field...
Ring id
State
Ring role
Master vlan
Topo group
Hello time
420
State
Ring
role
enabled
member
Interface role
primary
secondary
RHPs rcvd
0
CLI display of MRP ring information
Displays...
The ring ID
The state of MRP. The state can be one of the following:
•
enabled – MRP is enabled
•
disabled – MRP is disabled
Whether this node is the master for the ring. The role can be one of the
following:
•
master
•
member
The ID of the master VLAN in the topology group used by this ring. If a
topology group is used by MRP, the master VLAN controls the MRP settings
for all VLANs in the topology group.
NOTE: The topology group ID is 0 if the MRP VLAN is not the master VLAN in
The topology group ID.
The interval, in milliseconds, at which the Forwarding port on the ring's
master node sends Ring Hello Packets (RHPs).
Master
Topo
vlan
group
2
not conf
Forwarding state
disabled
forwarding
TC RHPs rcvd
0
a topology group. Using a topology group for MRP configuration is
optional.
Hello
Prefwing
time(ms)
time(ms)
100
300
Active interface
none
ethernet 2
Tunnel
State changes
4
BigIron RX Series Configuration Guide
53-1002253-01