How Dai Works - Dell PowerConnect B-RX Configuration Manual

35
Dynamic ARP inspection

How DAI works

DAI allows only valid ARP requests and responses to be forwarded.
A Brocade device on which DAI is configured does the following:
•
•
•
•
When you enable DAI on a VLAN, by default, all member ports are untrusted. You must manually
configure trusted ports. In a typical network configuration, ports connected to host ports are
untrusted. You configure ports connected to other switches or routers as trusted.
DAI inspects ARP packets received on untrusted ports, as shown in
inspection based on IP-to-MAC address bindings stored in a trusted binding database. For the
BigIron RX, the binding database is the ARP table, which supports DAI, DHCP snooping, and IP
Source Guard. To inspect an ARP request packet, DAI checks the source IP and source MAC
address against the ARP table. For an ARP reply packet, DAI checks the source IP, source MAC,
destination IP, and destination MAC addresses. DAI forwards the valid packets and discards those
with invalid IP-to-MAC address bindings.
When ARP packets reach a trusted port, DAI lets them through, as shown in
FIGURE 133
ARP entries
DAI uses the IP/MAC mappings in the ARP table to validate ARP packets received on untrusted
ports.
ARP entries in the ARP table derive from the following:
•
•
1002
Intercepts ARP packets received by the system CPU.
Inspects all ARP requests and responses received on untrusted ports.
Verifies that each of the intercepted packets has a valid IP-to-MAC address binding before
updating the local ARP table, or before forwarding the packet to the appropriate destination.
Drops invalid ARP packets
Dynamic ARP Inspection at work
ARP
packet
Dynamic ARP – normal ARP learned from trusted ports.
Static ARP – statically configured IP/MAC/port mapping.
DAI
Brocade Device
Figure 133. DAI carries out the
Figure 133.
ARP
packet
BigIron RX Series Configuration Guide
53-1002253-01