Configuring Bfd For Is-Is - Dell PowerConnect B-RX Configuration Manual

29
Configuring BFD for the specified protocol
Enabling BFD for OSPFv3 for all interfaces
You can configure BFD for OSPFv3 on all of a router's OSPFv3 enabled interfaces using the
command shown in the following.
BigIron RX(config)# ipv6 router ospf
BigIron RX(config-ospf6-router)# bfd all-interfaces
Syntax: [no] bfd all-interfaces
While this command configures BFD for OSPFv3 on all of a router's OSPFv3 enabled interfaces, it is
not required that it be configured if you use the ipv6 ospf bfd command to configure specific
interfaces. It can be used independently or together with that command.
Enabling or disabling BFD for OSPFv3 for a specific interface
You can selectively enable or disable BFD on any OSPFv3 interface as shown in the following.
BigIron RX#(config-if-e1000-3/1)# ipv6 ospf bfd
Syntax: ipv6 ospf bfd [disable]
The disable option disables BFD for OSPFv3 on the interface.

Configuring BFD for IS-IS

You can configure your BigIron RX router for BFD for the IS-IS protocol for all IS-IS enabled
interfaces or for specific interfaces as shown in the following sections.
Enabling BFD for IS-IS for all interfaces
You can configure IS-IS for IS-IS on all of a router's IS-IS enabled interfaces using the command
shown in the following"
BigIron RX(config)# router isis
BigIron RX(config-isis-router)# bfd all-interfaces
Syntax: [no] bfd all-interfaces
While this command configures BFD for IS-IS on all of a router's IS-IS enabled interfaces, it is not
required that it be configured if you use the isis bfd command to configure specific interfaces. It
can be used independently or together with that command.
Enabling or disabling BFD for IS-IS for a specific interface
You can selectively enable or disable BFD on any IS-IS interface as shown in the following.
BigIron RX#(config-if-e1000-3/1)# isis bfd
Syntax: isis bfd [disable]
The disable option disables BFD for IS-IS on the interface.
912 BigIron RX Series Configuration Guide
53-1002253-01