5
Enabling or disabling routing protocols
BigIron RX(config)# show terminal
Length: 24 lines
Page display mode (session): enabled
Page display mode (global): enabled
Syntax: show terminal
Enabling or disabling routing protocols
The BigIron RX supports the following protocols:
•
•
•
•
•
•
•
•
•
By default, IP routing is enabled on the device. All other protocols are disabled, so you must enable
them to configure and use them.
NOTE
The following protocols require a system reset before the protocol will be active on the system: PIM,
DVMRP, RIP, FSRP. To reset a system, enter the reload command at the privileged level of the CLI.
To enable a protocol on a device, enter router at the global CONFIG level, followed by the protocol to
be enabled. The following example shows how to enable OSPF.
BigIron RX(config)# router ospf
BigIron RX(config)# end
BigIron RX# write memory
BigIron RX# reload
Syntax: router bgp | dvmrp | ospf | pim | rip | vrrp | vrrpe
Displaying and modifying system parameter default settings
The device has default table sizes for the following parameters. The table sizes determine the
maximum number of entries the tables can hold. You can adjust individual table sizes to
accommodate your configuration needs.
•
•
•
•
•
130
BGP4
DVMRP
FSRP
IP
OSPF
PIM
RIP
VRRP
VRRPE
MAC address entries
Layer 2 Port VLANs supported on a system
Layer 3 Protocol VLANs supported on a system
Layer 4 sessions supported
IP cache size
BigIron RX Series Configuration Guide
53-1002253-01