Configuring An Mstp Instance; Configuring Port Priority And Port Path Cost; Configuring Bridge Priority For An Mstp Instance - Dell PowerConnect B-RX Configuration Manual

40
802.1s Multiple Spanning Tree Protocol
The revision parameter specifies the revision level for MSTP that you are configuring on the switch.
It can be a number from 0 and 65535.

Configuring an MSTP instance

An MSTP instance is configured with an MSTP ID for each region. Each region can contain one or
more VLANs. To configure an MSTP instance and assign a range of VLANs, use a command such as
the following at the Global Configuration level.
BigIron RX(config) # mstp instance 7 vlan 4 to 7
Syntax: [no] mstp instance <instance-number> [ vlan <vlan-id> | vlan-group <group-id> ]
The instance parameter defines the number for the instance of MSTP that you are configuring.
The vlan parameter assigns one or more VLANs or a range of VLANs to the instance defined in this
command.
The vlan-group parameter assigns one or more VLAN groups to the instance defined in this
command.

Configuring port priority and port path cost

Priority and path cost can be configured for a specified instance. To configure an MSTP instance,
use a command such as the following at the Global Configuration level.
BigIron RX(config)# mstp instance 7 ethernet 3/1 priority 32 path-cost 200
Syntax: [no] mstp instance <instance-number> ethernet <slot/port> priority <port-priority>
path-cost <cost>
The <instance-number> variable is the number of the instance of MSTP that you are configuring
priority and path cost for.
The ethernet <slot/port> parameter specifies a port within a VLAN. The priority and path cost
configured with this command will apply to VLAN that the port is contained within.
You can set a priority to the port that gives it forwarding preference over lower priority instances
within a VLAN or on the switch. A higher number for the priority variable means a lower forwarding
priority. Acceptable values are 0 - 240 in increments of 16. The default value is 128.
A path-cost can be assigned to a port to bias traffic towards or away from a path during periods of
rerouting. Possible values are 1 - 200000000.

Configuring bridge priority for an MSTP instance

Priority can be configured for a specified instance. To configure priority for an MSTP instance, use a
command such as the following at the Global Configuration level.
BigIron RX(config)# mstp instance 1 priority 8192
Syntax: [no] mstp instance <instance-number> priority <priority-value>
The <instance-number> variable is the number for the instance of MSTP that you are configuring.
1054 BigIron RX Series Configuration Guide
53-1002253-01