Convergence After A Link Failure - Dell PowerConnect B-RX Configuration Manual

13
Convergence in a simple topology
The Port2/Switch 2 bridge also sends an RST BPDU with an agreed flag Port2/Switch 1 that Port2
is the new Root port. Both ports go into forwarding states.
Now, Port3/Switch 3 is currently in a discarding state and is negotiating a port role. It received RST
BPDUs from Port3/Switch 2. The RSTP algorithm determines that the RST BPDUs Port3/Switch 3
received are superior to those it can transmit; however, they are not superior to those that are
currently being received by the current Root port (Port4). Therefore, Port3 retains the role of
Alternate port.
Ports 3/Switch 1 and Port5/Switch 1 are physically connected. Port5/Switch 1 received RST
BPDUs that are superior to those received on Port3/Switch 1; therefore, Port5/Switch 1 is given
the Backup port role while Port3 is given the Designated port role. Port3/Switch 1, does not go
directly into a forwarding state. It waits until the forward delay time expires twice on that port before
it can proceed to the forwarding state.
Once convergence is achieved, the active Layer 2 forwarding path converges as shown in
Figure
FIGURE 55
Bridge priority = 1500
Bridge priority = 2000

Convergence after a link failure

What happens if a link in the RSTP topology fails?
For example, Port2/Switch, which is the port that connects Switch 2 to the root bridge (Switch 1),
fails. Both Switch 2 and Switch 1 notice the topology change
376
55.
Active Layer 2 path
Switch 2
Port3
Designated
port
Port3
Alternate
port
Switch 3
Indicates the active Layer 2 path
Port3
Designated
port
Port2
Port2 Designated
Root port port
Port4
Designated port
Port4
Root port
(Figure
Port5
Backup port
Switch 1
Bridge priority = 1000
56).
BigIron RX Series Configuration Guide
53-1002253-01