Dell PowerConnect B-RX Configuration Manual page 347

This section needs work. More info on this parm in the LLDP-MED spec.
BigIron RX(config)#lldp advertise port-protocol-vlan-id none ports e 2/4 to 2/12
The port and protocol VLAN ID advertisement will appear similar to the following on the remote
device, and in the CLI display output on the Brocade device (show lldp local-info):
Syntax: [no] lldp advertise port-protocol-vlan-id none ports ethernet <port list> | all
For <port list>, specify the port(s) in the format [<slotnum>/]<portnum>, where <slotnum> is
required on chassis devices only. You can list all of the ports individually, use the keyword to to
specify a range of ports, or a combination of both. To apply the configuration to all ports on the
device, use the keyword all instead of listing the ports individually.
Untagged VLAN ID
The port VLAN ID TLV advertises the Port VLAN Identifier (PVID) that will be associated with
untagged or priority-tagged frames. If the port is not an untagged member of any VLAN (i.e., the
port is strictly a tagged port), the value zero will indicate that.
By default, the port VLAN ID is automatically advertised when LLDP is enabled on a global basis. To
disable this advertisement, enter a command such as the following.
BigIron RX(config)#no lldp advertise port-vlan-id ports e 2/4 to 2/12
The untagged VLAN ID will appear similar to the following on the remote device, and in the CLI
display output on the Brocade device (show lldp local-info).
Syntax: [no] lldp advertise port-vlan-id ports ethernet <slotnum/portnum> | all
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.
Protocol Identity
<<Supported?>>
The protocol ID TLV indicates the availability of certain protocols on a port (for example, STP, RSTP,
MSTP, etc.).
802.3 capabilities
Except for Power-via-MDI information, the Brocade device will advertise the following 802.3
attributes when LLDP is enabled on a global basis:
•
•
•
Link aggregation
This section needs work
BigIron RX Series Configuration Guide
53-1002253-01
Port-Protocol VLAN ID: not supported
Port VLAN ID: 99
Link aggregation information
MAC/PHY configuration and status
Maximum frame size
9
Configuring LLDP
271