Displaying Information About A Stack - Dell S3048-ON Configuration Manual

Displaying Information about a Stack

To display information about the stack, use the following command.
• Display for stack-identity, status, and hardware information on every unit in a stack.
EXEC Privilege mode
show system
• Display most of the information in show system, but in a more convenient tabular form.
EXEC Privilege mode
show system brief
• Display the same information in show system, but only for the specified unit.
EXEC Privilege mode
show system stack-unit
• Display topology and stack link status for the entire stack.
EXEC Privilege mode
show system stack-ports [status | topology]
Examples of the show system Commands
Display information about a switch stack using the show system command.
The following is an example of the show system command to view the stack details.
Dell#show system
Stack MAC
Reload-Type
-- Unit 3 --
Unit Type
Status
Next Boot
Required Type
Current Type
Master priority
Hardware Rev
Num Ports
Up Time
Dell Networking OS Version : 9.8(0.0P2)
Jumbo Capable
POE Capable
FIPS Mode
Burned In MAC
No Of MACs
-- Power Supplies
Unit Bay Status
------------------------------------------------------------
3 1 up
3 2 absent
-- Fan Status --
Unit Bay TrayStatus
------------------------------------------------------------
3 1 up
3 2 up
3 3 down
814 Stacking
: 00:12:13:34:12:40
: normal-reload [Next boot : normal-reload]
: Management Unit
: online
: online
: S3048-ON - 52-port GE/TE (SG-ON)
: S3048-ON - 52-port GE/TE (SG-ON)
: 0
: 0.0
: 52
: 18 min, 28 sec
: yes
: no
: disabled
: 00:12:13:34:12:40
: 3
--
Type FanStatus
AC up
absent
Fan1 Speed
up 18000
up 18000
FanSpeed(rpm)
8064
0