Ip Forwarding Cache; Basic Ip Parameters And Defaults - Dell PowerConnect B-RX Configuration Manual

7

Basic IP parameters and defaults

To configure a static IP route, refer to
To clear a route from the IP route table, refer to
To increase the size of the IP route table for learned and static routes, refer to
modifying system parameter default settings"
•
•

IP forwarding cache

The device maintains a software cache table for fast processing of IP packets that are forwarded or
generated by the CPU. The cache also contains forwarding information that is normally contained in
the IP routing table. For example, the cache contains information on the physical outgoing port,
priority, VLAN, and the type of cache entry. Also, cache entries have hardware information, which is
useful for debugging and aging.
There are two types of IP cache entries.
1. Directly connected host entries – These entries are created when the CPU receives the first
2. Network entries – These entries are created when a route table entry is created in software.
Here is an example of an entry in the IP forwarding cache.
1
Each IP forwarding cache entry contains the IP address of the destination, and the IP address and
MAC address of the next-hop router interface to the destination. If the destination is actually an
interface configured on the device itself, as shown here, then next-hop information indicates this.
The port through which the destination is reached is also listed, as well as the VLAN and Layer 4
QoS priority associated with the destination if applicable.
To display the IP forwarding cache, refer to
Basic IP parameters and defaults
IP is enabled by default. The following protocols are disabled by default:
•
•
•
156
For learned routes, modify the ip-route parameter.
For static routes, modify the ip-static-route parameter.
packet destined to a directly connected host. Host entries are set to age out after a certain
period if no traffic is seen for that entry.
These entries are not subjected to aging. A route table entry is created when routes are
learned by routing protocols such as OSPF or when routes are statically configured.
IP Address Next Hop
192.168.1.11 DIRECT
Route exchange protocols (RIP, OSPF, BGP4)
Multicast protocols (IGMP, PIM-DM, PIM-SM, DVMRP)
Router redundancy protocols (VRRPE, VRRP, FSRP)
"Configuring static routes"
"Clearing IP routes"
on page 130.
MAC
0000.0000.0000
"Displaying the forwarding cache"
on page 198.
on page 231.
"Displaying and
Type Port Vlan
PU n/a
on page 226.
BigIron RX Series Configuration Guide
53-1002253-01
Pri
0