Configuring Spanning Tree Protocol; Ieee 802.1D Spanning Tree Protocol (Stp); Enabling Or Disabling Stp - Dell PowerConnect B-RX Configuration Manual

Configuring Spanning Tree Protocol

IEEE 802.1D Spanning Tree Protocol (STP)

The BigIron RX supports Spanning Tree Protocol (STP) as described in the IEEE 802.10-1998
specification. STP eliminates Layer 2 loops in networks, by selectively blocking some ports and
allowing other ports to forward traffic, based on configurable bridge and port parameters. STP
also ensures that the least cost path is taken when multiple paths exist between ports or VLANs. If
the selected path fails, STP searches for and then establishes an alternate path to prevent or limit
retransmission of data.
NOTE
The total number of supported STP, RSTP, or MSTP indices is 128.

Enabling or disabling STP

STP is disabled by default on the device. Thus, new VLANs you configure on the device have STP
disabled by default.
TABLE 71
Device type
BigIron RX
By default, each VLAN on a BigIron RX runs a separate spanning tree instance. Each device has
one VLAN (VLAN 1) by default that contains all of its ports. However, if you configure additional
port-based VLANs on a device, then each of those VLANs on which STP is enabled and VLAN 1 all
run separate spanning trees.
You can enable or disable STP on the following levels:
•
•
•
Enabling or disabling STP globally
Use the following methods to enable or disable STP on the device on which you have not configured
VLANs.
BigIron RX Series Configuration Guide
53-1002253-01
Table 71 lists the default STP states for the device.
Default STP states
Default STP type
Brocade's multiple instances of
spanning tree
Globally – Affects all VLANs on the device.
Individual VLAN – Affects all ports within the specified VLAN. When you enable or disable STP
within a VLAN, the setting overrides the global setting. Thus, you can enable STP for the ports
within a VLAN even when STP is globally disabled, or disable the ports within a port-based
VLAN when STP is globally enabled.
Individual port – Affects only the individual port. However, if you change the STP state of the
primary port in a trunk group, the change affects all ports in the trunk group.
Default STP state Default STP state of new
VLANs
Disabled Disabled
Chapter
12
327