Configuring Route Flap Dampening - Dell PowerConnect B-RX Configuration Manual

•
•
To display the cooperative filtering configuration on the device, enter a command such as the
following. The line shown in bold type shows the cooperative filtering status.
BigIron RX# show ip bgp neighbor 10.10.10.1
1
Syntax: show ip bgp neighbor <ip-addr>
To display the ORFs received from a neighbor, enter a command such as the following.
BigIron RX# show ip bgp neighbor 10.10.10.1 received prefix-filter
ip prefix-list 10.10.10.1: 4 entries
Syntax: show ip bgp neighbor <ip-addr> received prefix-filter

Configuring route flap dampening

A "route flap" is the change in a route's state, from up to down or down to up. When a route's state
changes, the state change causes changes in the route tables of the routers that support the route.
Frequent changes in a route's state can cause Internet instability and add processing overhead to
the routers that support the route.
Route flap dampening is a mechanism that reduces the impact of route flap by changing a BGP4
router's response to route state changes. When route flap dampening is configured, the device
suppresses unstable routes until the route's state changes reduce enough to meet an acceptable
degree of stability. The Brocade implementation of route flap dampening is based on RFC 2439.
Route flap dampening is disabled by default. You can enable the feature globally or on an
individual route basis using route maps.
BigIron RX Series Configuration Guide
53-1002253-01
The cooperative filtering configuration on the device.
The ORFs received from neighbors.
IP Address: 10.10.10.1, AS: 65200 (IBGP), RouterID: 10.10.10.1
State: ESTABLISHED, Time: 0h0m7s, KeepAliveTime: 60, HoldTime: 180
RefreshCapability: Received
CooperativeFilteringCapability: Received
Messages: Open
Sent : 1
Received: 1
Last Update Time: NLRI
Tx: ---
Last Connection Reset Reason:Unknown
Notification Sent:
Notification Received: Unspecified
TCP Connection state: ESTABLISHED
Byte Sent: 110, Received: 110
Local host: 10.10.10.2, Local
Remote host: 10.10.10.1, Remote Port: 179
ISentSeq: 460
TotSent: 111
IRcvSeq: 7349
TotalRcv: 111
SendQue:
seq 5 permit 10.10.0.0/16 ge 18 le 28
seq 10 permit 20.20.10.0/24
seq 15 permit 30.0.0.0/8 le 32
seq 20 permit 40.10.0.0/16 ge 18
Update KeepAlive Notification Refresh-Req
0 1 0
0 1 0
Withdraw
---
Unspecified
Port: 8138
SendNext:
ReTrans:
RcvNext: 7460
DupliRcv:
0 RcvQue:
Filtering
1
1
NLRI Withdraw
Rx: --- ---
571 TotUnAck:
0 UnAckSeq:
SendWnd: 16384
0 RcvWnd: 16384
0 CngstWnd:
26
0
571
5325
811