Setting Maximum Frame Size Per Ppcr - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

7
Configuring packet parameters
The control portions of these packets differ slightly. All IP devices on an Ethernet network must use
the same format. The device uses Ethernet II by default. You can change the IP encapsulation to
Ethernet SNAP on individual ports if needed.
NOTE
All devices connected to the device port must use the same encapsulation type.
To change the IP encapsulation type on interface 1/5 to Ethernet SNAP, enter the following
commands.
BigIron RX(config)# int e 1/5
BigIron RX(config-if-e1000-1/5)# ip encapsulation snap
Syntax: ip encapsulation snap | ethernet-2

Setting maximum frame size per PPCR

You can set a maximum frame size of IP packets that are forwarded on all ports of a PPCR. You can
set a maximum frame size globally and per interface.
Globally setting the maximum frame size (jumbo frame)
To set a maximum frame size (otherwise referred to as jumbo frame) that applies to the device,
enter a command such as the following.
BigIron RX(config)# default-max-frame-size 2000
BigIron RX(config)# write memory
BigIron RX(config)# reload
Syntax: default-max-frame-size <bytes>
Enter 64 – 9212 for <bytes>. The default is 1518 bytes.
Setting a maximum frame size per interface
When you set a maximum frame size on an interface, that size applies to all ports in a PPCR.
Table 49
TABLE 49
Module type
24 x 1G
To set a maximum frame size for all the ports attached to a PPCR, enter a command such as the
following at the Interface Configuration level.
BigIron RX(config)#interface ethernet 6/4
BigIron RX(config-if-e1000-6/4)#max-frame-size 1500 bytes
BigIron RX(config-if-e1000-6/4)#write memory
BigIron RX(config-if-e1000-6/4)#exit
BigIron RX(config)#reload
In this example the maximum frame size is applied to port 4 of a 24 x 1G Ethernet Interface
module. That means that this maximum will apply to ports 1 to 10 on the interface module.
180
shows the ports of each Interface module.
Available ports per PPCR
Number of packet
processors (PPCR)
2
Ports in a PPCR
PPCR1
PPCR2
1 - 12
13 - 24
PPCR3
PPCR4
N/A
N/A
BigIron RX Series Configuration Guide
53-1002253-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents