Displaying Vsrp Information; Displaying Vrid Information - Dell PowerConnect B-RX Configuration Manual

15

Displaying VSRP information

FIGURE 83
There are no CLI commands used to configure this process.
Displaying VSRP information
You can display the following VSRP information:
•
•

Displaying VRID information

To display detailed VSRP information, enter the show vsrp vrid or show vsrp vlan command. Both
commands show the same information as in the following example.
BigIron RX# show vsrp vrid 100
VLAN 10
Auth-type no authentication
VRID 10
========
State Administrative-status Advertise-backup Preempt-mode
Master Enabled Disabled True
Parameter Configured Current Unit/Formula
Priority 100 80 (100-0)*(4.0/5.0)
Hello-interval 1 1 sec/10
Dead-interval 3 3 sec/10
Hold-interval 3 3 sec/10
Initial-ttl 2 2 hops
Backup-Hello 60 60 sec/10
Next hello sent in 00:00:01
Member ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 11/1 ethe 14/1
Operational ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1
Forwarding ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1
Restart ports: 3/1(10) 3/3(10) 6/1(10) 11/1(10) 14/1(10)
Syntax: show vsrp [vrid <num> | vlan <vlan-id>]
442
New path established
Path 1
MRP
Master
MRP
MRP
Member
MRP Member
VSRP Backup
VSRP
X
Device 1
Configuration information and current parameter values for a VRID or VLAN
The interfaces on a VSRP-aware device that are active for the VRID
MRP
Host
Member
MRP Member
VSRP Master
Path 2
MRP
Member
MRP MRP
Member
Member
MRP Master
MRP Member
VSRP Backup
VSRP Master
VSRP
X
Device 1
BigIron RX Series Configuration Guide
MRP
Host
53-1002253-01