Using Wred With Rate Limiting; Configuring Packet Drop Priority Using Wred; Enabling Wred; Setting The Averaging-Weight (Wq) Parameter - Dell PowerConnect B-RX Configuration Manual

Pdrop =

Using WRED with rate limiting

When rate limiting is configured on a device, it directs the switch to drop traffic indiscriminately
when the configured average-rate and maximum-burst thresholds are exceeded. If rate limiting is
configured with WRED, the traffic that exceeds these thresholds can be subjected to the WRED
algorithm which drops packets selectively by priority.
In this configuration, packets that exceed the thresholds established by the rate limiting
configuration are marked as either exceeding the average-rate or maximum-burst threshold. This
marking is then used to select a WRED configuration that determines which packets to drop.

Configuring packet drop priority using WRED

For a description of WRED, refer to
This section describes how to configure the parameters described in that section to enable the use
of WRED on a device.
To configure WRED, you must configure the following parameters:
•
•
•

Enabling WRED

WRED must be enabled on any forwarding queue that you want it to operate on. To enable WRED
for the forwarding queue 3, enter the following command.
BigIron RX(config)#qos queue-type 3 wred enable
Syntax: [no] qos queue-type <queue-number> wred enable
The <queue-number> variable is the number of the forwarding queue that you want to enable
WRED for. There are four forwarding queues on device. They are numbered 0 to 3 with zero as the
lowest priority queue and three the highest.

Setting the averaging-weight (Wq) parameter

The Wq parameter is configured as the averaging-weight parameter. In this implementation, you
can set one of 13 (1 - 13) possible values. These values represent a Wq value as described in
Table 96
TABLE 96
Averaging weight
setting
1
2
BigIron RX Series Configuration Guide
53-1002253-01
pkt-size
----------------- * Pmax * -----------------------------------------
pkt-size-max
"Enabling WRED"
"Setting the averaging-weight (Wq) parameter"
"Configuring the drop precedence parameters"
Possible Wq values
Configuring packet drop priority using WRED
(avg-q-size - min-avg-q size)
(max-avg-q-size - min-avg-q size)
"Determining packet drop priority using WRED"
Wq value as a percentage
50%
25%
18
on page 487.
489