Dell PowerConnect B-RX Configuration Manual page 474

13
Displaying RSTP information
BigIron RX# show xstp Ethernet 3/1
STP information:
--------------------------------------------------------------------
No STP-configured VLANs for the port 3/1
RSTP information:
----------------------------------------------------------------------------
RSTP (IEEE 802.1w)Port Parameters:
VLAN ID: 11
<--- Config Params ---> | <--- Current state --->
Port
Num
3/1
RSTP (IEEE 802.1w) Port Parameters:
VLAN ID: 313
<--- Config Params --> | <--- Current state --->
Port
Num
3/1
MSTP information:
----------------------------------------------------------------------------
No MSTP-configured VLANs for the port 3/1
Syntax: show xstp ethernet <slot/port>
The ethernet <slot/port>parameter displays the rstp protocol information for the specified
Ethernet interface.
TABLE 82
This field...
<slot/port>
RSTP (IEEE 802.1W) port parameters
Port Num
Pri
Port Path Cost
398
Pri PortPath P2P Edge Role
Cost Mac Port
128 20000 F F
Pri PortPath P2P Edge Role
Cost Mac Port
128 20000 F F
CLI display of RSTP information for the specified Ethernet interface
State
DESIGNATED DISCARDING 0
State
DESIGNATED FORWARDING 0
Displays...
The RSTP protocol information for the specified ethernet interface.
NOTE: If the Ethernet interface is not added to any RSTP enabled
VLANs, the command displays the following message instead:
"No RSTP-configured VLANs for the port <slot/port>".
The port number shown in a slot#/port# format.
The configured priority of the port. The default is 128 or 0x80.
The configured path cost on a link connected to this port.
Designa- Designated
ted cost bridge
8000000cdbf5ee00
Designa- Designated
ted cost bridge
8000000cdbf5ee00
BigIron RX Series Configuration Guide
53-1002253-01