Redistributing Static Routes - Dell PowerConnect B-RX Configuration Manual

26
Modifying redistribution parameters
The match internal | external1 | external2 parameter applies only to OSPF. This parameter
specifies the types of OSPF routes to be redistributed into BGP4. The default is internal.
NOTE
If you do not enter a value for the match parameter, (for example, you enter redistribute ospf only)
then only internal OSPF routes will be redistributed.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
OSPF route to the BGP4 route table.
NOTE
The route map you specify must already be configured on the router. Refer to
on page 801 for information about defining route maps.
NOTE
If you use both the redistribute ospf route-map <map-name> command and the redistribute ospf
match internal | external1 | external2 command, the software uses only the route map for filtering.
Redistributing ISIS
To configure the device to redistribute ISIS routes, enter the following command.
BigIron RX(config-bgp)# redistribute isis level-1
Syntax: redistribute isis level-1 | level-1-2 | level-2 [metric <num>] [route-map <map-name>]
The isis parameter indicates that you are redistributing ISIS routes into BGP4.
The level-1 parameter redistributes ISIS routes only within the area the routes.
The level-2 parameter redistributes ISIS routes between areas within a domain.
The level-1-2 parameter redistributes ISIS routes within the area of the routes and between areas
within a domain.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295.
The default
is not assigned.
The route-map <map-name> parameter specifies a route map to be consulted before adding the
OSPF route to the BGP4 route table.

Redistributing static routes

To configure the device to redistribute static routes, enter the following command.
BigIron RX(config-bgp)# redistribute static
Syntax: redistribute static [metric <num>] [route-map <map-name>]
The static parameter indicates that you are redistributing static routes into BGP4.
788
"Defining route maps"
BigIron RX Series Configuration Guide
53-1002253-01