Displaying The Multicast Traffic Engineering Configuration - Dell PowerConnect B-RX Configuration Manual

To limit the multicast traffic through the packet processor that includes port 1/1 to 10 Mbps, use
the following command.
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e1000-1/1)# qos multicast best-effort rate 10000
Syntax: qos multicast best-effort rate <rate>
The <rate> variable defines the bandwidth of multicast traffic that is allowed to pass through the
packet processor that include the port this command is configured on. On a 24-port x 1 Gbps
Interface module, a qos multicast command applied to any of the ports numbered 1 to 12 will
apply to all of these ports. Any command applied to ports numbered 13 to 24 will apply to these
ports.
This variable is configured in Kbps.
The minimum configurable rate is 10 Mbps.

Displaying the multicast traffic engineering configuration

To view multicast traffic engineering configurations, use the following command.
BigIron RX#show qos multicast
Port
--------+-------------------
13/1
13/2
13/3
13/4
13/5
13/6
13/7
13/8
13/9
13/10
13/11
13/12
13/13
13/14
13/15
13/16
13/17
13/18
13/19
13/20
13/21
13/22
13/23
13/24
Syntax: show qos multicast [<portnum>]
The <portnum> variable allow you to optionally limit the display to an individual port.
•
•
BigIron RX Series Configuration Guide
53-1002253-01
| Best Effort
| Bandwidth (Kbps)
|
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 140000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
| 12000000
16-port 10 Gigabit EtherneBigIron RXThe 16-port 10 Gigabit Ethernet module works in Server
mode by default.Mirror (analyzer) ports cannot be assigned to the 16x10GE card. You can
monitor traffic on 16x10 ports.
Brocade currently only support "strict" and "destination-weighted" scheduling schemes.
Configuring multicast traffic engineering
18
499