Displaying Mbgp Information; Displaying Summary Mbgp Information - Dell PowerConnect B-RX Configuration Manual

The <ip-addr> and <ip-mask> parameters specify the aggregate value for the networks.
The as-set parameter causes the router to aggregate AS-path information for all the routes in the
aggregate address into a single AS-path.
The summary-only parameter prevents the router from advertising more specific routes contained
within the aggregate route.
The suppress-map <map-name> parameter prevents the more specific routes contained in the
specified route map from being advertised.
The advertise-map <map-name> parameter configures the device to advertise the more specific
routes in the specified route map.
The attribute-map <map-name> parameter configures the device to set attributes for the
aggregate routes based on the specified route map.
NOTE
For the suppress-map, advertise-map, and attribute-map parameters, the route map must already
be defined.

Displaying MBGP information

All of the BGP show commands have MBGP equivalents. Use mbgp instead of bgp in the command
syntax. For example, to display the MBGP route table, enter the show ip mbgp routes command
instead of the show ip bgp routes command.
describes their output. For information about a command, refer to
(IPv4 and
TABLE 133
Command
show ip mbgp summary
show ip mbgp config
show ip mbgp neighbors
show ip mbgp peer-group
show ip mbgp routes
show ip mbgp <ip-addr>[/<prefix>]
show ip mbgp attribute-entries
show ip mbgp dampened-paths
show ip mbgp flap-statistics
show ip mbgp filtered-routes
The following sections show examples of some of the MBGP show commands. An example of the
show ip mroute command is also included. This command displays the IP multicast route table.

Displaying summary MBGP information

To display summary MBGP information, enter the following command at any CLI prompt.
BigIron RX Series Configuration Guide
53-1002253-01
IPv6)".
MBGP Show commands
Displaying MBGP information
Table 133 lists the MBGP show commands and
Description
Displays summary configuration information and statistics.
Shows the configuration commands in the running-config.
Displays information about MBGP neighbors.
Displays information about MBGP peer groups.
Displays MBGP routes.
Displays a specific MBGP route.
Displays MBGP route attributes.
Displays MBGP paths that have been dampened by route flap
dampening.
Displays route flap dampening statistics.
Displays routes that have been filtered out.
Chapter 26, "Configuring BGP4
27
863