Configuring The Strict Password Feature - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

4
Setting up local user accounts
NOTE
Password minimum and combination requirements are strictly enforced.

Configuring the strict password feature

Use the enable strict-password-enforcement command to enable the password security feature.
Enter a command such as the following.
BigIron RX(config)# enable strict-password-enforcement
Syntax: [no] enable strict-password-enforcement
This feature is disabled by default.
When the command is configured, the passwords that users create for their accounts must not
share four or more concurrent characters with any other passwords configured on the device;
otherwise, the following error message is displayed.
Error - The substring <str> within the password has been used earlier, please
choose a different password.
Also, if the user tries to use a password that was previously configured, Local User Account
configuration will not be allowed and the following message will be displayed.
This password was used earlier for same or different user, please choose a
different password."
When you create a password, the characters you type are masked.
Example : To create a password for the enable login.
BigIron RX(config)# user sandy password TesT12$%
Syntax: [no] user <username> password <password>
Example : To assign a password for a user account.
BigIron RX(config)# username sandy password [Enter]
Enter password: ********
Syntax: [no] username <name> password
78
Users must accept the message of the day when they log in.
Users are locked out (disabled) if they fail to login in three login attempts.
The last 15 passwords are stored in the CLI.
A password can be set to expire.
Passwords are masked during password creation.
Passwords must not share four or more concurrent characters with any other password
configured on the device.
Passwords that were previously used cannot be reused.
When an enable and a user password is created, it must have a minimum of eight characters
containing the following combinations:
At least two upper case characters
At least two lower case characters
At least two numeric characters
At least two special character
BigIron RX Series Configuration Guide
53-1002253-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents