Enabling Snmp To Configure Tacacs And Tacacs - Dell PowerConnect B-RX Configuration Manual

•
•
TACACS configuration procedure
For TACACS configurations, use the following procedure.
1. Identify TACACS servers. Refer to
2. Set optional parameters. Refer to
3. Configure authentication-method lists. Refer to
TACACS+ configuration procedure
For TACACS+ configurations, use the following procedure.
1. Enable TACACS, refer to
2. Identify TACACS+ servers. Refer to
3. Set optional parameters. Refer to
4. Configure authentication-method lists. Refer to
5. Optionally configure TACACS+ authorization. Refer to
6. Optionally configure TACACS+ accounting. Refer to

Enabling SNMP to configure TACACS and TACACS

TACACS is disabled by default. To enable SNMP access to TACACS MIB objects on the device, enter
the following command.
BigIron RX(config)#enable snmp config-tacacs
Syntax: [no] enable snmp <config-radius | config-tacacs>
The <config-radius> parameter specifies the RADIUS configuration mode. Radius is disabled by
default.
The <config-tacacs> parameter specifies the TACACS configuration mode. TACACS is disabled by
default.
BigIron RX Series Configuration Guide
53-1002253-01
You can select only one primary authentication method for each type of access to a device (CLI
through Telnet, CLI Privileged EXEC and CONFIG levels). For example, you can select TACACS+
as the primary authentication method for Telnet CLI access, but you cannot also select RADIUS
authentication as a primary method for the same type of access. However, you can configure
backup authentication methods for each access type.
You can configure the Brocade device to authenticate using a TACACS or TACACS+ server, not
both.
page 89.
TACACS and TACACS+" on page 90.
"Enabling SNMP to configure TACACS and TACACS"
page 89.
TACACS and TACACS+" on page 90.
page 92.
page 95.
Configuring TACACS and TACACS+ security
"Identifying the TACACS and TACACS+ servers"
"Setting optional TACACS and TACACS+ parameters"
"Configuring authentication-method lists for
"Identifying the TACACS and TACACS+ servers"
"Setting optional TACACS and TACACS+ parameters"
"Configuring authentication-method lists for
"Configuring TACACS+ authorization"
"Configuring TACACS+ accounting"
4
on page 88.
on
on page 87
on page 88.
on
on
on
87